is this supposed to be there
July 22nd, 2012, 5:57 AM
#3
There are 10 check ***** total.
3 in the case side (two in 'capsules') and one loose beside the 3-4 accumulator bore. Then, there are also 7 on the valve body side.
Look for the "bathtubs" in the channeling on the valve body.
Allan
3 in the case side (two in 'capsules') and one loose beside the 3-4 accumulator bore. Then, there are also 7 on the valve body side.
Look for the "bathtubs" in the channeling on the valve body.
Allan
July 22nd, 2012, 9:33 AM
#5
No,
The ball shouldn't be "jammed" or "stuck" into the spacer plate.
You may be able to turn the plate upsidedown on a flat surface and bring it flat again with a hammer.
However, if the hole is enlarged or 'torn', you'd better get a new plate.
Allan
The ball shouldn't be "jammed" or "stuck" into the spacer plate.
You may be able to turn the plate upsidedown on a flat surface and bring it flat again with a hammer.
However, if the hole is enlarged or 'torn', you'd better get a new plate.
Allan
Thread
Thread Starter
Forum
Replies
Last Post
sleekpete
Other
0
April 23rd, 2011 3:10 PM
Mud_Truckin
Silverado & Fullsize Pick-ups
4
June 4th, 2009 1:53 PM
livinloud
Silverado & Fullsize Pick-ups
3
January 10th, 2007 5:13 PM
